Thesis (M.A.) from the year 2019 in the subject Electrotechnology, grade: 9, , language: English, abstract: The Orthogonal Frequency Division Multiplexing (OFDM) is an important aspect of multicarrier digital data transmission system where a single data stream is transmitted into a several number of lower rates subcarrier signals. In this thesis, there are five different types of the techniques introduced to strengthen the communication quality and capacity. This kind of new standard of transmission of data is the first one to perform with OFDM in data packet based communication system. In wireless communication network, the abstraction of parallel transmission of data symbols is implemented to attain high throughput and effective transmission quality. The OFDM is a method to deal with parallel transmission.

Orthogonal Frequency Division Multiplexing for Wireless Communications is an edited volume with contributions by leading authorities in the subject of OFDM. Its coverage consists of principles, important wireless topics (e.g. Synchronization, channel estimation, etc.) and techniques. Included is information for advancing wireless communication in a multipath environment with an emphasis on implementation of OFDM in base stations. Orthogonal Frequency Division Multiplexing for Wireless Communications provides a comprehensive introduction of the theory and practice of OFDM. To facilitate the readers, extensive subject indices and references are given at the end of the book. Even though each chapter is written by different experts, symbols and notations in all chapters of the book are consistent.

Orthogonal Frequency Division Multiplexing (OFDM) systems are widely used in the standards for digital audio/video broadcasting, WiFi and WiMax. Being a frequency-domain approach to communications, OFDM has important advantages in dealing with the frequency-selective nature of high data rate wireless communication channels. As the needs for operating with higher data rates become more pressing, OFDM systems have emerged as an effective physical-layer solution. This short monograph is intended as a tutorial which highlights the deleterious aspects of the wireless channel and presents why OFDM is a good choice as a modulation that can transmit at high data rates. The system-level approach we shall pursue will also point out the disadvantages of OFDM systems especially in the context of peak to average ratio, and carrier frequency synchronization. Finally, simulation of OFDM systems will be given due prominence. Simple MATLAB programs are provided for bit error rate simulation using a discrete-time OFDM representation. Software is also provided to simulate the effects of inter-block-interference, inter-carrier-interference and signal clipping on the error rate performance. Different components of the OFDM system are described, and detailed implementation notes are provided for the programs. The program can be downloaded here. Table of Contents: Introduction / Modeling Wireless Channels / Baseband OFDM System / Carrier Frequency Offset / Peak to Average Power Ratio / Simulation of the Performance of OFDM Systems / Conclusions

Supported by the expert-level advice of pioneering researchers, Orthogonal Frequency Division Multiple Access Fundamentals and Applications provides a comprehensive and accessible introduction to the foundations and applications of one of the most promising access technologies for current and future wireless networks. It includes authoritative cove

Orthogonal Frequency Division Multiplexing (OFDM) systems are widely used in the standards for digital audio/video broadcasting, WiFi and WiMax. Being a frequency-domain approach to communications, OFDM has important advantages in dealing with the frequency-selective nature of high data rate wireless communication channels. As the needs for operating with higher data rates become more pressing, OFDM systems have emerged as an effective physical-layer solution. This short monograph is intended as a tutorial which highlights the deleterious aspects of the wireless channel and presents why OFDM is a good choice as a modulation that can transmit at high data rates. The system-level approach we shall pursue will also point out the disadvantages of OFDM systems especially in the context of peak to average ratio, and carrier frequency synchronization. Finally, simulation of OFDM systems will be given due prominence. Simple MATLAB programs are provided for bit error rate simulation using a discrete-time OFDM representation. Software is also provided to simulate the effects of inter-block-interference, inter-carrier-interference and signal clipping on the error rate performance. Different components of the OFDM system are described, and detailed implementation notes are provided for the programs. The program can be downloaded here. Table of Contents: Introduction / Modeling Wireless Channels / Baseband OFDM System / Carrier Frequency Offset / Peak to Average Power Ratio / Simulation of the Performance of OFDM Systems / Conclusions

"The book examines several aspects of Orthogonal Frequency Division Multiplexing (OFDM) employing linear diversity techniques such as inter-carrier interference, bit error rate, peak to average power and inter-block interference. It should be a useful refe"

Multi-carrier modulation, in particular orthogonal frequency division multiplexing (OFDM), has been successfully applied to a wide variety of digital communications applications for several years. Although OFDM has been chosen as the physical layer standard for a diversity of important systems, the theory, algorithms, and implementation techniques remain subjects of current interest. This book is intended to be a concise summary of the present state of the art of the theory and practice of OFDM technology. This book offers a unified presentation of OFDM theory and high speed and wireless applications. In particular, ADSL, wireless LAN, and digital broadcasting technologies are explained. It is hoped that this book will prove valuable both to developers of such systems, and to researchers and graduate students involved in analysis of digital communications, and will remain a valuable summary of the technology, providing an understanding of new advances as well as the present core technology.

The drive towards higher spectral efficiency and maximum power efficiency in optical systems has generated renewed interest in the optimization of optical transceivers. In this work, we study the different optical applications: Wide Area Networks (WANs), Metropolitan Area Networks (MANs), Local Area Networks (LANs) and Personal Area Networks (PANs). In WANs or long-haul systems, orthogonal frequency-division multiplexing (OFDM) can compensate for linear distortions, such as group-velocity dispersion (GVD) and polarization-mode dispersion (PMD), provided the cyclic prefix is sufficiently long. Typically, GVD is dominant, as it requires a longer cyclic prefix. Assuming coherent detection, we show how to analytically compute the minimum number of subcarriers and cyclic prefix length required to achieve a specified power penalty, trading off power penalties from the cyclic prefix and from residual inter-symbol interference (ISI) and inter-carrier interference (ICI). We derive an analytical expression for the power penalty from residual ISI and ICI. We also show that when nonlinear effects are present in the fiber, single-carrier with digital equalization outperforms OFDM for various dispersion maps. We also study the impairments of electrical to optical conversion when using Mach-Zehnder (MZ) modulators. OFDM has a high peak-to-average ratio (PAR), which can result in low optical power efficiency when modulated through a Mach-Zehnder (MZ) modulator. In addition, the nonlinear characteristic of the MZ can cause significant distortion on the OFDM signal, leading to in-band intermodulation products between subcarriers. We show that a quadrature MZ with digital pre-distortion and hard clipping is able to overcome the previous impairments. We consider quantization noise and compute the minimum number of bits required in the digital-to-analog converter (D/A). Finally, we discuss a dual-drive MZ as a simpler alternative for the OFDM modulator, but our results show that it requires a higher oversampling ratio to achieve the same performance as the quadrature MZ. In MANs, we discuss the use OFDM for combating GVD effects in amplified direct-detection (DD) systems using single-mode fiber. We review known direct-detection OFDM techniques, including asymmetrically clipped optical OFDM (ACO-OFDM), DC-clipped OFDM (DC-OFDM) and single-sideband OFDM (SSB-OFDM), and derive a linearized channel model for each technique. We present an iterative procedure to achieve optimum power allocation for each OFDM technique, since there is no closed-form solution for amplified DD systems. For each technique, we minimize the optical power required to transmit at a given bit rate and normalized GVD by iteratively adjusting the bias and optimizing the power allocation among the subcarriers. We verify that SSB-OFDM has the best optical power efficiency among the different OFDM techniques. We compare these OFDM techniques to on-off keying (OOK) with maximum-likelihood sequence detection (MLSD) and show that SSB-OFDM can achieve the same optical power efficiency as OOK with MLSD, but at the cost of requiring twice the electrical bandwidth and also a complex quadrature modulator. We compare the computational complexity of the different techniques and show that SSB-OFDM requires fewer operations per bit than OOK with MLSD. In LANs, we compare the performance of several OFDM schemes to that of OOK in combating modal dispersion in multimode fiber links. We review known OFDM techniques using intensity modulation with direct detection (IM/DD), including DC-OFDM, ACO-OFDM and pulse-amplitude modulated discrete multitone (PAM-DMT). We describe an iterative procedure to achieve optimal power allocation for DC-OFDM, and compare analytically the performance of ACO-OFDM and PAM-DMT. We also consider unipolar M-ary pulse-amplitude modulation (M-PAM) with minimum mean-square error decision-feedback equalization (MMSE-DFE). For each technique, we quantify the optical power required to transmit at a given bit rate in a variety of multimode fibers. For a given symbol rate, we find that unipolar M-PAM with MMSE-DFE has a better power performance than all OFDM formats. Furthermore, we observe that the difference in performance between M-PAM and OFDM increases as the spectral efficiency increases. We also find that at a spectral efficiency of 1 bit/symbol, OOK performs better than ACO-OFDM using a symbol rate twice that of OOK. At higher spectral efficiencies, M-PAM performs only slightly better than ACO-OFDM using twice the symbol rate, but requires less electrical bandwidth and can employ analog-to-digital converters at a speed only 81% of that required for ACO-OFDM. In PANs, we evaluate the performance of the three IM/DD OFDM schemes in combating multipath distortion in indoor optical wireless links, comparing them to unipolar M-PAM with MMSE-DFE. For each modulation method, we quantify the received electrical SNR required at a given bit rate on a given channel, considering an ensemble of 170 indoor wireless channels. When using the same symbol rate for all modulation methods, M-PAM with MMSE-DFE has better performance than any OFDM format over a range of spectral efficiencies, with the advantage of M-PAM increasing at high spectral efficiency. ACO-OFDM and PAM-DMT have practically identical performance at any spectral efficiency. They are the best OFDM formats at low spectral efficiency, whereas DC-OFDM is best at high spectral efficiency. When ACO-OFDM or PAM-DMT are allowed to use twice the symbol rate of M-PAM, these OFDM formats have better performance than M-PAM. When channel state information is unavailable at the transmitter, however, M-PAM significantly outperforms all OFDM formats. When using the same symbol rate for all modulation methods, M-PAM requires approximately three times more computational complexity per processor than all OFDM formats and 63% faster analog-to-digital converters, assuming oversampling ratios of 1.23 and 2 for ACO-OFDM and M-PAM, respectively. When OFDM uses twice the symbol rate of M-PAM, OFDM requires 23% faster analog-to-digital converters than M-PAM but OFDM requires approximately 40% less computational complexity than M-PAM per processor.

Orthogonal frequency-division multiplexing (OFDM) is a method of digital modulation in which a signal is split into several narrowband channels at different frequencies. CDMA is a form of multiplexing, which allows numerous signals to occupy a single transmission channel, optimising the use of available bandwidth. Multiplexing is sending multiple signals or streams of information on a carrier at the same time in the form of a single, complex signal and then recovering the separate signals at the receiving end. Multi-Carrier (MC) CDMA is a combined technique of Direct Sequence (DS) CDMA (Code Division Multiple Access) and OFDM techniques. It applies spreading sequences in the frequency domain. Wireless communications has witnessed a tremendous growth during the past decade and further spectacular enabling technology advances are expected in an effort to render ubiquitous wireless connectivity a reality. This technical in-depth book is unique in its detailed exposure of OFDM, MIMO-OFDM and MC-CDMA. A further attraction of the joint treatment of these topics is that it allows the reader to view their design trade-offs in a comparative context. Divided into three main parts: Part I provides a detailed exposure of OFDM designed for employment in various applications Part II is another design alternative applicable in the context of OFDM systems where the channel quality fluctuations observed are averaged out with the aid of frequency-domain spreading codes, which leads to the concept of MC-CDMA Part III discusses how to employ multiple antennas at the base station for the sake of supporting multiple users in the uplink Portrays the entire body of knowledge currently available on OFDM Provides the first complete treatment of OFDM, MIMO(Multiple Input Multiple Output)-OFDM and MC-CDMA Considers the benefits of channel coding and space time coding in the context of various application examples and features numerous complete system design examples Converts the lessons of Shannon’s information theory into design principles applicable to practical wireless systems Combines the benefits of a textbook with a research monograph where the depth of discussions progressively increase throughout the book This all-encompassing self-contained treatment will appeal to researchers, postgraduate students and academics, practising research and development engineers working for wireless communications and computer networking companies and senior undergraduate students and technical managers.

OFDM is a modulation technique that achieves high data rates, increased bandwidth efficiency and robustness in multipath environments. However, OFDM has some disadvantages, such as sensitivity to channel fading, large peak to average ratio and sensitivity to frequency offset. The latter causes intercarrier interference (ICI) and a reduction in the amplitude of the desired subcarrier which results in loss of orthogonality. In this thesis, the effects of frequency offset are studied in terms of loss of orthogonality. A number of techniques for frequency offset estimation are presented and tested in computer simulations.