This report presents the results of a state-of-the-art survey covering tantalum and seven of its alloys. All data are given in tabular and graphical form covering some of the more important physical, mechanical, and metallurgical properties for each material. References are given at the conclusion of each material section.

The results of a state-of-the-art survey covering tungsten and ten of its alloys are presented. All data are given in tabular and graphical form covering some of the more important physical, mechanical, and metallurgical properties for each material. References are given at the conclusion of each material section.

The results of a state-of-the-art survey covering niobium and 18 of its most promising alloys are presented. All data are given in tabular and graphical form covering some of the more important physical, mechanical, and metallurgical properties for each material. References are given at the conclusion of each material section.

This report summarizes the information generated since the middle of 1961 on the chemical, physical, and mechanical properties of refractory metals that are coated with oxidation-resistant coatings of advanced-experimental or commercial status. It is a supplement to DMIC Report 162, Coatings for the Protection of Refractory Metals from Oxidation, dated November 24, 1961. Recent data on specific silicide- and aluminide- type coatings for columbium, molybdenum, tantalum, and tungsten and their alloys reflect general advances in coating quality and performance, understanding of the behavior of coated systems, and more complete realization of the problems associated with the use of coated hardware.

To aid in quick identification and easy location of specific technical data and information in the various reports and memoranda which have been prepared and distributed by the Defense Metals Information Center, as well as by DMIC's forerunner, the Titanium Metallurgical Laboratory, a classification by major subject matter was prepared. The classification covers reports through DMIC Report 193 and memoranda through DMIC Memorandum 183. (Author).