Progress made in applying advanced techniques and structural concepts to the problem of strengthening the Group VI-A metals, Cr, Mo, and W, is examined. At low temperatures, T/Tm

This publication documents Proceedings of the Symposium on Metal lurgy and Technology of Refractory Metal Alloys, held in Washington, D.C. at the Washington Hilton Hotel on April 25-26, 1968, under sponsorship of the Refractory Metals Committee, Institute of Metals Division, of the Metallurgical Society of AIME, and the National Aeronautics and Space Administration. The Symposium presented critical reviews of selected topics in refractory metal alloys, thereby contributing to an in-depth understanding of the state-of-the-art, and establishing a base line for further research, development, and application. This Symposium is fifth in a series of conferences on refractory metals, sponsored by the Metallurgical Society of AlME. Publications issuing from the conferences are valuable technical and historical source books, tracing the evolution of refractory metals from early laboratory alloying studies to their present status as useful engineering materials. Refractory metals are arbitrarily defined by melting point. A 0 melting temperature of over 3500 F was selected as the minimum for this Symposium, thus excluding chromium and vanadium, which logically could be treated with other refractory metals in Groups VA and VIA of the periodic table. The Refractory Metals Committee is planning reviews of chromium and vanadium in subsequent conferences.

This report is the third of a series which will periodically summarize the status of the various contracts involved in the Department of Defense Refractory Metals Sheet Rolling Program. Under this program, selected candidate materials are being carried through one or more of the following consecutive phases: Phase I, development of a sheet-production practice; Phase II, establishment of minimum design data; and Phase III, evaluation of sheetfabrication characteristics. To the present time, 13 contracts have been funded or planned in support of the Phase I, II, and III activities. This report summarizes the status of each of these individual contracts as of November 1, 1964. The first section describes the overall program of the Department of Defense Refractory Metals Sheet Rolling Program. Following, in the order of their discussions, are sections dealing with fabricable molybdenum alloys, unalloyed tungsten, columbium alloys, and tantalum alloys. (Author).

This report summarizes the information generated since the middle of 1961 on the chemical, physical, and mechanical properties of refractory metals that are coated with oxidation-resistant coatings of advanced-experimental or commercial status. It is a supplement to DMIC Report 162, Coatings for the Protection of Refractory Metals from Oxidation, dated November 24, 1961. Recent data on specific silicide- and aluminide- type coatings for columbium, molybdenum, tantalum, and tungsten and their alloys reflect general advances in coating quality and performance, understanding of the behavior of coated systems, and more complete realization of the problems associated with the use of coated hardware.