This study presents the results of one of the first attempts to characterize the pore water pressure response of soils subjected to traffic loading under saturated and unsaturated conditions. It is widely known that pore water pressure develops within the soil pores as a response to external stimulus. Also, it has been recognized that the development of pores water pressure contributes to the degradation of the resilient modulus of unbound materials. In the last decades several efforts have been directed to model the effect of air and water pore pressures upon resilient modulus. However, none of them consider dynamic variations in pressures but rather are based on equilibrium values corresponding to initial conditions. The measurement of this response is challenging especially in soils under unsaturated conditions. Models are needed not only to overcome testing limitations but also to understand the dynamic behavior of internal pore pressures that under critical conditions may even lead to failure. A testing program was conducted to characterize the pore water pressure response of a low plasticity fine clayey sand subjected to dynamic loading. The bulk stress, initial matric suction and dwelling time parameters were controlled and their effects were analyzed. The results were used to attempt models capable of predicting the accumulated excess pore pressure at any given time during the traffic loading and unloading phases. Important findings regarding the influence of the controlled variables challenge common beliefs. The accumulated excess pore water pressure was found to be higher for unsaturated soil specimens than for saturated soil specimens. The maximum pore water pressure always increased when the high bulk stress level was applied. Higher dwelling time was found to decelerate the accumulation of pore water pressure. In addition, it was found that the higher the dwelling time, the lower the maximum pore water pressure. It was concluded that upon further research, the proposed models may become a powerful tool not only to overcome testing limitations but also to enhance current design practices and to prevent soil failure due to excessive development of pore water pressure.

In recent decades the development of unsaturated soil mechanics has been remarkable, resulting in momentous advances in fundamental knowledge, testing techniques, computational procedures, prediction methodologies and geotechnical practice. The advances have spanned the full spectrum of theory and practice. In addition, unsaturated materials exhibiting complex behaviour such as residual soils, swelling soils, compacted soils, collapsing soils, tropical soils and solid wastes have been integrated in a common understanding of shared behaviour features. It is also noteworthy that unsaturated soil mechanics has proved surprisingly fruitful in expanding to other neighbouring areas such as swelling rocks, rockfill mechanics, and freezing soils. As a consequence, geotechnical engineering involving unsaturated soils can be now approached from a more rational and systematic perspective leading towards an improved and more effective practice. Unsaturated Soils contains the papers presented at the 5th International Conference on Unsaturated Soil (Barcelona, Spain, 6-8 September 2010). They report significant advances in the areas of unsaturated soil behaviour, testing techniques, constitutive and numerical modelling and applications. The areas of application include soil-atmosphere interaction, foundations, slopes, embankments, pavements, geoenviromental problems and emerging topics. They are complemented by three keynote lectures and three general reports covering general issues of modelling, testing and applications. Unsaturated Soils is a comprehensive record of the state-of-the art in unsaturated soil mechanics and a sound basis for further progress in the future. The two volumes will serve as an essential reference for academics, researchers and practitioners interested in unsaturated soils.

This book (including a 969 pages full paper USB device) deals with the geotechnics of roads, railways and airfields. Providing economic and sustainable transportation infrastructures for societies is highly dependent on progress made in this field, and the contributions are of interest to professionals and academics involved in geotechnical and pavement engineering of roads, railways and airfields.

This dissertation, "Failure of Saturated Sandy Soils Due to Increase in Pore Water Pressure" by Sainulabdeen Mohamed, Junaideen, was obtained from The University of Hong Kong (Pokfulam, Hong Kong) and is being sold pursuant to Creative Commons: Attribution 3.0 Hong Kong License. The content of this dissertation has not been altered in any way. We have altered the formatting in order to facilitate the ease of printing and reading of the dissertation. All rights not granted by the above license are retained by the author. Abstract: Abstract of thesis entitled FAILURE OF SATURATED SANDY SOILS DUE TO INCREASE IN PORE WATER PRESSURE Submitted by Sainulabdeen Mohamed Junaideen for the degree of Doctor of Philosophy at The University of Hong Kong in January 2005 Most slope failures are attributable to an increase in pore water pressure during or following periods of intense rainfall. These failures are induced by reduction of effective confining stress whilst shear stress remains nearly constant, as opposed to the failures caused by increasing shear stress in standard laboratory tests. Although the significance of the different stress paths has been recognized, studies of soil behaviour in constant shear stress path, which closely represents conditions during a rise in pore water pressure, have been scarce. Furthermore, past studies suggest that the steady state line is not unique and the volume change tendency of soils is stress path-dependent. These findings make it difficult to predict the behaviour of soils during a rise in pore water pressure. Nevertheless, there is an urgent need to study such behaviour as rainfall-induced slope failures occur in various types of soils and occasionally turn into debris flows, posing a serious risk to both life and property. The principal objectives of this study were to characterize the soil behaviour during a rise in pore water pressure and to examine existing theories in respect of the instability of soils. A comprehensive testing program, which included load-controlled constant shear stress path tests and standard strain rate-controlled undrained tests, was conducted on completely decomposed granites. Specimens prepared at various densities were used for the tests. A fast data-acquisition system was utilized so that readings during rapid deformations could also be recorded. The study's findings showed that the steady state line was reasonably unique for a given soil and that the volume change tendency was not path-dependent. The steady state concept could be used to explain soil behaviour during a rise in pore water pressure; and the difference between the current void ratio and the void ratio at the steady state at the current stress level could be used to characterize soil behaviour. Instability of the soils occurs at higher stress ratios in the constant shear stress path than in the undrained loading stress path. To define the instability state due to a rise in pore water pressure, the post-peak portion of undrained effective stress paths is of very limited use for this type of soil. Conversely, using the constant shear test results, the instability state can be adequately defined for soils of various densities. Furthermore, the concept of collapse surface can be extended to define the instability state of soils of various densities due to undrained loading. DOI: 10.5353/th_b3070854 Subjects: Shear strength of soils Slopes (Soil mechanics) Sandy soils - Testing

The principles and concepts for unsaturated soils are developed as extensions of saturated soils. Addresses problems where soils have a matric suction or where pore-water pressure is negative. Covers theory, measurement and use of the fundamental properties of unsaturated soils--permeability, shear strength and volume change. Includes a significant amount of case studies.

Most soft clays in their natural state exhibit a small degree of overconsolidation resulting from changes in ground water level, delayed consolidation, or other causes. The overconsolidation ratio is commonly in the range of 1.0 to 2.5. Under surface loading pore pressures in such a deposit will develop as for an elastic material until the effective stresses reach a yield condition or failure condition. In the latter case the soil can continue to carry additional total stresses within confined zones and pore pressures in these zones will continue to increase. In the former case the soil will continue to deform plastically until it reaches failure, showing, in general, different pore pressure responses in these two phases. Thus pore pressure response at any point in a soft clay deposit under increasing surface loading may show two or three distinct phases, although in some cases the plastic and failure responses may be almost indistinguishable. In this report evidence is presented for the yield condition from a study of published laboratory test results. Expressions are then developed for the pore pressures to be expected in the field for each of the three phases -- elastic, plastic, and contained failure -- as a function of the vertical total stress increment at any point in the soil mass. (Author).

Unsaturated Soil Mechanics is the first book to provide a comprehensive introduction to the fundamental principles of unsaturated soil mechanics. * Offers extensive sample problems with an accompanying solutions manual. * Brings together the rapid advances in research in unsaturated soil mechanics in one focused volume. * Covers advances in effective stress and suction and hydraulic conductivity measurement.