In the mid 1980's - while a student at the department of econometrics at the Free University - I became an assistant at the Institute for Environmental Studies (IvM) of this university. My main task was assisting with the com putational aspects of the project 'an integrated environmental model: a case study in the Markiezaat area'. A number of methodological problems were for mulated during the operationalization phase of that project, such as the need to develop systematically an integrated model design and to look for means of handling different sources of information. Prof. Dr. P. Nijkamp of the Department of Regional Economics and Drs. L. Hordijk - at that time leader of the economic-technological research group at the IvM - therefore initiated a project proposal to be supported by the Netherlands Organisation for the Advancement of Pure Research (ZWO). Meanwhile I became an assistant to Prof. Dr. P. Nijkamp, surveying qualita ti ve statistical developments in the field of regional inequa li ty analysis. This inventory has been shown to be a relevant basis for the preparation of this book. In spring 1982 I began working at IvM on the above project on integrated environmental modelling.

The complex and multidisciplinary nature of environmental problems requires that they are dealt with in an integrated manner. Modeling and software have become key instruments used to promote sustainability and improve environmental decision processes, especially through systematic integration of various knowledge and data and their ability to foster learning and help make predictions. This book presents the current state-of-the-art in environmental modeling and software and identifies the future challenges in the field. - State-of-the-art in environmental modeling and software theory and practice for integrated assessment and management serves as a starting point for researchers - Identifies the areas of research and practice required for advancing the requisite knowledge base and tools, and their wider usage - Best practices of environmental modeling enables the reader to select appropriate software and gives the reader tools to integrate natural system dynamics with human dimensions

Table of Contents Preface Chapter 1 Introduction to Modeling the Transport and Transformation of Contaminants in the Environment Chapter 2 Nature of Environnemental Polluants Chapter 3 Inter-Media Contaminant Transfer: Equilibrium Analysis Chapter 4 Kinetics of Inter-media Chapter 5 Transport Fundamentals Chapter 6 Overview of Numerical Methods in Environmental Modeling Chapter 7 Overview of Probabilistic Methods and Tools for Modeling Chapter 8 Models of Transport in Air Chapter 9 Models of Transport in Individual Media: Soil and Groundwater Chapter 10 Models of Transport in Surface Water Chapter 11 Atmospheric Transformation and Loss Processes Chapter 12 Modeling Chemical Transformations in Water Chapter 13 Exposure and Risk Assessment Chapter 14 Tools for Evaluation, Analysis and Optimization of Environmental Models Index.

Covering the more recent advances in Modelling, Planning, Management and Negotiations for Integrated Water Resource Management, this text brings together knowledge and concepts from Hydrology, System Analysis, Control Theory, Conflict Resolution, and Decision and Negotiation Theory. Without compromising on mathematical rigour, the book maintains a fine line between theory and application, methodology and tools, avoiding getting locked into excessively theoretical and formal development of the issues discussed. The non-technical aspects of water resource systems (such as societal, political and legal concerns) are recognized throughout the book as having a great, if not fundamental, importance to reaching an agreed-upon decision; they are therefore integrated into the more technical and mathematical issues. The book provides a unified, coordinated and comprehensive framework that will facilitate the increasingly appropriate application of the Integrated Water Resource Management paradigm by current and future practising professionals, decision-makers and scientists.· Integration of technical modelling and control aspects with participatory and decision-making issues· Insightful and comprehensive treatment of theoretical contents, supported by practical examples· A wide collection of exercises and project examples based on real-world case studies (with complete solutions)

The discipline of Integrated Environmental Modelling (IEM) has developed in order to solve complex environmental problems, for example understanding the impacts of climate change on the physical environment. IEM provides methods to fuse or link models together, this in turn requires facilities to make models discoverable and also to make the outputs of modelling easily visualized. The vision and challenges for IEM going forward are summarized by leading proponents. Several case studies describe the application of model fusion to a range of real-world problems including integrating groundwater and recharge models within the UK Environment Agency, and the development of ‘catastrophe’ models to predict better the impact of natural hazards. Communicating modelling results to end users who are often not specialist modellers is also an emerging area of research addressed within the volume. Also included are papers that highlight current developments of the technology platforms underpinning model fusion.

Global warming and population growth have resulted in an increase in the intensity of natural and anthropogenic stressors. Investigating the complex nature of environmental problems requires the integration of different environmental processes across major components of the environment, including water, climate, ecology, air, and land. Cumulative effects assessment (CEA) not only includes analyzing and modeling environmental changes, but also supports planning alternatives that promote environmental monitoring and management. Disjointed and narrowly focused environmental management approaches have proved dissatisfactory. The adoption of integrated modelling approaches has sparked interests in the development of frameworks which may be used to investigate the processes of individual environmental component and the ways they interact with each other. Integrated modelling systems and frameworks are often the only way to take into account the important environmental processes and interactions, relevant spatial and temporal scales, and feedback mechanisms of complex systems for CEA. This book examines the ways in which interactions and relationships between environmental components are understood, paying special attention to climate, land, water quantity and quality, and both anthropogenic and natural stressors. It reviews modelling approaches for each component and reviews existing integrated modelling systems for CEA. Finally, it proposes an integrated modelling framework and provides perspectives on future research avenues for cumulative effects assessment.

Simulation models are an established method used to investigate processes and solve practical problems in a wide variety of disciplines. Central to the concept of this second edition is the idea that environmental systems are complex, open systems. The authors present the diversity of approaches to dealing with environmental complexity and then encourage readers to make comparisons between these approaches and between different disciplines. Environmental Modelling: Finding Simplicity in Complexity 2nd edition is divided into four main sections: An overview of methods and approaches to modelling. State of the art for modelling environmental processes Tools used and models for management Current and future developments. The second edition evolves from the first by providing additional emphasis and material for those students wishing to specialize in environmental modelling. This edition: Focuses on simplifying complex environmental systems. Reviews current software, tools and techniques for modelling. Gives practical examples from a wide variety of disciplines, e.g. climatology, ecology, hydrology, geomorphology and engineering. Has an associated website containing colour images, links to WWW resources and chapter support pages, including data sets relating to case studies, exercises and model animations. This book is suitable for final year undergraduates and postgraduates in environmental modelling, environmental science, civil engineering and biology who will already be familiar with the subject and are moving on to specialize in the field. It is also designed to appeal to professionals interested in the environmental sciences, including environmental consultants, government employees, civil engineers, geographers, ecologists, meteorologists, and geochemists.

A participatory and integrated procedure for the planning of water resources is presented and illustrated through its application to a real-world case study: the planning of a trans-boundary, multi-purpose, regulated lake. Methods and concepts from Hydrology, System Analysis, Optimal Control, Decision and Negotiation Theory are presented and framed in a comprehensive and coherent procedure for the efficient development of the decision-making process. Relevant theoretical and mathematical aspects are briefly presented for the non-expert reader, as well as all those practical details that are often omitted in texts, but that constitute the very essence of a project and make the difference between a successful project and a failure. The book provides practicing professionals, decision-makers and scientists with a complete, immediate example of application of the Integrated Water Resource Management paradigm. Complete development of a real world application of IWRM Integration of technical modelling and control aspects with participatory and decision-making issues