This report provides an engineering analysis of, and status report on, selected enhancements for soil vapor extraction (SVE) treatment technologies. The report is intended to assist project managers considering an SVE treatment system by providing them with an up-to-date status of enhancement technologies; an evaluation of each technology's applicability to various site conditions; a presentation of cost and performance information; a list of vendors specializing in the technologies; a discussion of relative strengths and limitations of the technologies; recommendations to keep in mind when considering the enhancements; and a compilation of references. The performance of an SVE system depends on properties of both the contaminants and the soil. SVE is generally applicable to compounds with a vapor pressure of greater than 1 millimeter of mercury at 20EC and a Henry s Law constant of greater than 100 atmospheres per mole fraction. SVE is most effective at sites with relatively permeable contaminated soil and with saturated hydraulic conductivities of greater than 1 x 10 or 1 x 10 centimeter per second (cm/s). SVE by itself does not effectively remove contaminants -3 -2 in saturated soil. However, SVE can be used as an integral part of some treatment schemes that treat both groundwater and the overlying vadose zone. Enhancement technologies should be considered when contaminant or soil characteristics limit the effectiveness of SVE or when contaminants are present in saturated soil. The five enhancement technologies covered in this report are as follows and are described in the following subsections: * Air Sparging * Dual-phase Extraction * Directional Drilling * Pneumatic and Hydraulic Fracturing * Thermal Enhancement.

This manual provides practical guidance for the design and operation of soil vapor extraction (SVE) and bioventing (BV) systems. It is intended for use by engineers, geologists, hydrogeologists, and soil scientists, chemists, project managers, and others who possess a technical education and some design experience but only the broadest familiarity with SVE or BV systems.

Every practicing environmental engineer should already have a firm grasp on the basics of hazardous waste site remediation-the key to confronting a site problem, and devising an effective solution. Since their original introduction to remediation, technology has kept moving ahead with new ideas and procedures. Fundamentals of Hazardous Waste Site Remediation gives environmental professionals immediate access to the basics of the trade, along with information about recent advancements. This comprehensive overview examines the basics of such areas as hazardous materials chemistry, hydrogeology, reaction engineering, and clean-up level development. A chapter on Cost Estimating will be of particular interest to specialists, in light of recent concerns about the increased costs of remediation. After reading each chapter, test your new knowledge with the review problems. As a refresher guide for career environmental engineers, or a helpful tool to newcomers in the field, Fundamentals of Hazardous Waste Site Remediation is a valuable resource for longtime professionals and newcomers alike.

Geoenvironmental Engineering covers the application of basic geological and hydrological science, including soil and rock mechanics and groundwater hydrology, to any number of different environmental problems. * Includes end-of-chapter summaries, design examples and worked-out numerical problems, and problem questions. * Offers thorough coverage of the role of geotechnical engineering in a wide variety of environmental issues. * Addresses such issues as remediation of in-situ hazardous waste, the monitoring and control of groundwater pollution, and the creation and management of landfills and other above-ground and in-situ waste containment systems.