The design and test results of two types of total temperature probes that were used for hypersonic boundary-layer measurements are presented. The intent of each design was to minimize the total error and to maintain minimal size for measurements in boundary layers 1.0 in. thick and less. A single platinum-20-percent-rhodium shield was used in both designs to minimize radiation heat transfer losses during exposure to the high-temperature test stream. The shield of the smaller design was flattened at the flow entrance to an interior height of 0.02 in., compared with 0.03 in. for the larger design. The resulting vent-to-inlet area ratios were 60 and 50 percent. A stainless steel structural support sleeve that was used in the larger design was excluded from the smaller design, which resulted in an outer diameter of 0.059 in., to allow closer placement of the probes to each other and to the wall. These small design changes to improve resolution did not affect probe performance. Tests were conducted at boundary-layer-edge Mach numbers of 5.0 and 6.2. The nominal free-stream total temperatures were 2600 degrees and 3200 degrees R. The probes demonstrated extremely good reliability. The best performance in terms of recovery factor occurred when the wire-based Nusselt number was at least 0.04. Recommendations for future probe designs are included. Albertson, Cindy W. and Bauserman, Willard A., Jr. Langley Research Center RTOP 506-43-21-01...

The predominant probes used for measuring total temperature in a compressible boundary-layer flow are described. The results of a direct comparison between two of these probes, the conical equilibrium temperature probe (Danberg probe) and the combined temperature-pressure probe of the DFVLR-AVA, are presented. The comparison was made by testing the probes simultaneously in the nozzle-wall turbulent boundary-layer flow of the NOL Boundary Layer Channel at zero and moderate heat-transfer conditions...

p="" This book focuses both on the basics and more complex topics in mechanical measurements such as measurement errors & statistical analysis of data, regression analysis, heat flux, measurement of pressure, and radiation properties of surfaces. End of chapter problems, solved illustrations, and exercise problems are presented throughout the book to augment learning. It is a useful reference for students in both undergraduate and postgraduate programs. ^