This guide primarily addresses contractors, builders and architects constructing roof structures with particular emphasis on MCR covered buildings. It provides hands-on advice on design and construction of roof trusses, layout drawings and constructions details as well as design aids.

An organized, structured approach to the 2018 INTERNATIONAL PLUMBING CODE Loose leaf Version, these TURBO TABS will help you target the specific information you need, when you need it. Packaged as pre-printed, full-page inserts that categorize the IPC into its most frequently referenced sections, the tabs are both handy and easy to use. They were created by leading industry experts who set out to develop a tool that would prove valuable to users in or entering the field.

Avoid pitfalls with these expert tips & techniques for diagnosing and preventing the most common residential building defects. More than 50 experts in the field describe their proven techniques for preventing building problems.

I I This book is intended to guide practicing structural engineers into more profitable routine designs with the AISC Load and Resistance Factor Design Specification (LRFD) for structural steel buildings. LRFD is a method of proportioning steel structures so that no applica ble limit state is exceeded when the structure is subjected to all appro priate factored load combinations. Strength limit states are related to safety, and concern maximum load carrying capacity, Serviceability limit states are related to performance under service load conditions such as deflections. The term "resistance" includes both strength states and serviceability limit states. LRFD is a new approach to the design of structural steel for buildings. It involves explicit consideration of limit states, multiple load factors and resistance factors, and implicit probabilistic determination of relia bility. The type of factoring used by LRFD differs from the allowable stress design of Chapters A through M of the 1989 Ninth Edition of the AISC Specifications for Allowable Stress Design, where only the resistance is divided by a factor of safety to obtain an allowable stress, and from the plastic design provisions of Chapter N, where the loads are multi plied by a common load factor of 1.7 for gravity loads and 1.3 for gravity loads acting with wind or seismic loads. LRFD offers the structural engineer greater flexibility, rationality, and economy than the previous 1989 Ninth Edition of the AISC Specifications for Allowable Stress Design.

Presents information on structural lumber grades, foundations, bracing, safety, structural loading, engineered wood products, stresses in wood, design load requirements, commodity storage structures, site planning, building codes, and more. For engineers, builders, and educators.

An easy to read handy pocket guide to roof construction, measurements and details. A must for all Builders. Well known throughout the industry as the Little Red Roofing book, it can be - or should be - found in the back of every roofer's ute.